Latest 50hz GPS Firmware

Post by **Ryan.g** » Mon Mar 15, 2021 5:43 am

This thread is for tracking the firmware builds for the Syvecs 50Hz Gps Modules. When a new release is available it will be added to the end of this thread.

A manual on how to flash the latest firmware is here http://www.syvecs.com/downloads/Syvecs_Updater.pdf

Any further Questions please E-mail support@syvecs.co.uk or speak to your nearest dealer

Post by **Ryan.g** » Mon Mar 15, 2021 5:50 am

Firmware 1.2 of the 50Hz GPS Module is attached below. This firmware will be loaded onto new sales from the 10/3/21 if you purchased before then we recommend updating.

Please use the Syvecs Updater program to load the ENC file. Guide here http://www.syvecs.com/downloads/Syvecs_Updater.pdf

ENSURE the GPS is sealed again if using in harsh environments with a silicon based sealant

The 1.2 Firmware fixes the following issues:

* Added Support for Bosch MM5 (see manual for Can Info - http://www.syvecs.com/downloads/Syvecs_ ... Module.pdf)
* Added Support for Motec M1 Series (see manual for Can Info - http://www.syvecs.com/downloads/Syvecs_ ... Module.pdf)
* Fixed Uart Boot Issue
* Faster Wakeup of Device on Canbus

Post by **Ryan.g** » Tue Dec 07, 2021 5:59 pm

Firmware 1.3 of the 50Hz GPS Module is attached below. This firmware will be loaded onto new sales from the 18/11/21 if you purchased before then we recommend updating.

Please use the Syvecs Updater program to load the ENC file. Guide here http://www.syvecs.com/downloads/Syvecs_Updater.pdf

ENSURE the GPS is sealed again if using in harsh environments with a silicon based sealant

The 1.3 Firmware fixes the following issues:

* GPS Chip firmware error which would cause the unit to not boot correctly

Post by **Ryan.g** » Thu Aug 18, 2022 10:06 am

Firmware 1.4 of the 50Hz/100Hz GPS Module is attached below.

Please use the Syvecs Updater program to load the ENC file. Guide here http://www.syvecs.com/downloads/Syvecs_Updater.pdf

ENSURE the GPS is sealed again if using in harsh environments with a silicon based sealant

The 1.4 Firmware fixes the following issues:

* Added support for 100hz new hardware
* Signed issue fixed on heading
* Speed Jumping issue fixed when stationary at high altitudes

Post by **Ryan.g** » Thu Feb 16, 2023 8:01 am

Firmware 1.5 of the 50Hz/100Hz GPS Module is attached below.

Please use the Syvecs Updater program to load the ENC file. Guide here http://www.syvecs.com/downloads/Syvecs_Updater.pdf

ENSURE the GPS is sealed again if using in harsh environments with a silicon based sealant

The 1.5 Firmware fixes the following issues:

* BugFix for 100hz IMU Data being 90deg out with New IC

Post by **Ryan.g** » Sun Feb 25, 2024 3:27 pm

Firmware 1.6 of the 50Hz/100Hz GPS Module is attached below.

Please use the Syvecs Updater program to load the ENC file. Guide here http://www.syvecs.com/downloads/Syvecs_Updater.pdf

ENSURE the GPS is sealed again if using in harsh environments with a silicon based sealant

The 1.6 Firmware fixes the following issues:

* Improvements for signal decoding in areas where sat data is limited